WIRELESS DOOR LOCK CONTROL SYSTEM > REGISTRATION |
| 1. REGISTER RECOGNITION CODE USING INTELLIGENT TESTER |
Select Add mode or Rewrite mode and perform the following operation:
Turn the ignition switch to the ON position.
Select the add or rewrite mode according to the intelligent tester display.
Press LOCK and UNLOCK on the transmitter simultaneously for more than 1 second. (Procedure "A")
Press either of the switches on the door control transmitter again for more than 1 second. (Procedure "B")
The body ECU automatically performs the power door LOCK-UNLOCK operation after the switch on the door control transmitter is turned off, in order to indicate whether registration has been completed correctly or not.

If registration is continued, the next recognition code must be registered in the door control transmitter within 40 seconds.
Completing the registration mode.
The registration mode will cease when any of the following occurs:
Perform the following after registration is completed.
Perform the wireless door lock control operation check (Click here).
Select Confirmation mode and perform the following operation:
Number of registered code is shown.
Registration procedures are completed.
| 2. REGISTER RECOGNITION CODE MANUAL OPERATION |
Ensure that the following conditions are met:
No key is in the ignition key cylinder.
Driver side door is opened (Other doors are closed).
Driver side door is unlocked.
When the above conditions are met, perform the following:
Insert and remove the key from the ignition key cylinder twice. (End in remove) (Procedure "A")
Close and open the driver side door twice. (End in open) (Procedure "B")
Insert and remove the key from the ignition key cylinder. (Procedure "C")
Close and open the driver side door twice. (End in open) (Procedure "D")
Insert the key into the ignition key cylinder and close all doors. (Procedure "E")
Turn the ignition switch from LOCK to ON and back to LOCK at approximately 1 second intervals according to the number of times shown in the illustration. (Procedure "F")

Remove the key from the ignition key cylinder. (Procedure "G")
The body ECU automatically performs the power door LOCK-UNLOCK operation within 3 seconds after the mode has been selected and informs the technician of the selected mode using the following response patterns.

Registration of the door control transmitter.
If the add mode or rewrite mode has been selected, press LOCK and UNLOCK on the transmitter simultaneously for more than 1 second. (Procedure "H")
Press either of the switches on the door control transmitter for more than 1 second. (Procedure "I")
The body ECU automatically performs the power door LOCK-UNLOCK operation within 3 seconds after the switch on the door control transmitter is turned off, in order to indicate whether registration has been completed correctly or not.

If registration is continued, the next recognition code must be registered in the door control transmitter within 40 seconds.
Completing the registration mode.
The registration mode will cease when any of the following occurs:
Perform the following after registration is completed.
Perform the wireless door lock control operation check (Click here).