Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Auto Up / Down Function does not Operate

for Preparation Click here


DESCRIPTION

If the AUTO UP/DOWN function does not operate, any of the following troubles may be the cause:
  1. When the PWR fuse or the power window relay (Marking: PWR) is replaced with new ones, or when the battery terminal and the connector of the power window master switch are disconnected, the power window memory of the fully closed position which is recorded in the power window master switch is erased.
  2. The pulse sensors in the driver side power window motor have a malfunction.
  3. There is an open or short circuit in the wiring between the power window master switch and the driver side power window motor.
  4. The power window master switch has a malfunction.

WIRING DIAGRAM


B062902E06


INSPECTION PROCEDURE

1.CHECK MANUAL UP/DOWN FUNCTION (DRIVER SIDE)
  1. Check that the door glass can be operated manually.



NG
OTHER PROBLEM
OK


2.CHECK ILLUMINATION OF POWER WINDOW MASTER SWITCH


    B067295
  1. Turn the ignition switch ON.

  1. Operate the AUTO (drive side) switch of the master switch.



  1. Check the blinking pattern of the AUTO light as shown in the illustration.

    1. If pattern (1) is displayed, proceed to A.

    2. If pattern (2) or (3) is displayed, proceed to B.



    3. If the normal pattern is displayed, proceed to C.


      B128873E01



B
Go to step 4

C
REPLACE POWER WINDOW MASTER SWITCH
A


3.RESET POWER WINDOW REGULATOR MOTOR
  1. Turn the ignition switch ON.

  1. Open the door glass.

  1. Fully pull up the AUTO switch of the power window master switch until the door glass is fully closed.

  1. Check that the AUTO UP/DOWN function operates normally.



OK
END
NG


4.CHECK WIRE HARNESS (MASTER SWITCH - MOTOR)


    B062894E02
  1. Disconnect the D17 master switch connector.

  1. Disconnect the P12 motor connector (driver side).

  1. Check the resistance between the wire harness side connectors.

    Standard resistance:
    Terminal No.
    Specified Condition
    D17-4 - P12-5
    Continuity
    D17-17 - P12-3
    D17-3 - P12-4
    D17-2 - P12-6
    D17-2 - P12-3
    No continuity
    D17-2 - P12-4
    D17-2 - P12-5



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (DRIVER SIDE)