Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1782/82    Stop Light Switch Circuit

for Preparation Click here


DESCRIPTION

When the brake pedal is depressed, the stop light comes on and the signal is input to the STP terminal of the suspension control ECU.

HINT:
This DTC is output only when the sensor signal check is done.


DTC No.
DTC Detecting Condition
Trouble Area
C1782/82
The signal from the stop light switch assembly does not change.
  1. Stop light switch assembly
  2. Stop light switch circuit
  3. Suspension control ECU

WIRING DIAGRAM


F050636E01


INSPECTION PROCEDURE

1.INSPECT STOP LIGHT
  1. Check that the stop light comes on when the brake pedal is depressed and goes off when the brake pedal is released.

    OK:
    Stop light operates normally.



NG
Go to step 3
OK


2.INSPECT SUSPENSION CONTROL ECU


    F043242E05
  1. Remove the suspension control ECU with connectors still connected.

  1. Measure the voltage between terminal S14-12 (STP) of the suspension control ECU and body ground when the stop light switch is ON and OFF.

    Standard voltage:
    Switch condition
    Specified condition
    Brake pedal depressed (ON)
    10 to 14 V
    Brake pedal released (OFF)
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU 

3.INSPECT STOP LIGHT SWITCH


    E065594E53
  1. Disconnect the stop light switch assembly connector.

  1. Check resistance between terminals 1 and 2 of the stop light switch assembly.

    Standard resistance:
    Switch condition
    Tester connection
    Specified condition
    Switch pin free
    1 - 2
    Below 1 Ω
    Switch pin pushed in
    1 - 2
    10 kΩ or higher



NG
REPLACE STOP LIGHT SWITCH
OK


4.INSPECT SUSPENSION CONTROL ECU


    F043242E05
  1. Remove the suspension control ECU with connectors still connected.

  1. Measure the voltage between terminal S14-12 (STP) of the suspension control ECU and body ground when the stop light switch is ON and OFF.

    Standard voltage:
    Switch condition
    Specified condition
    Brake pedal depressed (ON)
    10 to 14 V
    Brake pedal released (OFF)
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU