Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1783/83    Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The door courtesy light switch turns on when the door is opened and turns off when the door is closed.
The signal is sent from the body ECU and the back door ECU into the DOOR terminal of the suspension control ECU when all the doors are open.

DTC No.
DTC Detecting Condition
Trouble Area
C1783/83
Door courtesy light switch signal does not change.
  1. Door courtesy light switch
  2. Back door lock assembly (Back door courtesy light switch)
  3. Door courtesy light switch circuit
  4. Body ECU
  5. Back door ECU
  6. Suspension control ECU

WIRING DIAGRAM


F043233E01


INSPECTION PROCEDURE

1.INSPECT COURTESY LIGHT SWITCH
  1. Check that the open door warning light comes on when any door or back door is opened and goes off when all the doors are closed.

    OK:
    Courtesy light operates normally.



NG
CHECK OPEN DOOR WARNING LIGHT
OK


2.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - BODY ECU)
  1. Check for open and short circuit in the harness and the connector between the suspension control ECU and the body ECU (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT BODY ECU (ACTY OUTPUT)


    F044280E01
  1. Remove the body ECU with connectors still connected.

  1. Measure the voltage between terminal B5-20 (ACTY) of the body ECU and body ground when door is opened and closed.

Standard voltage:
Door condition
Specified condition
Each door opened
Below 1.5 V
All doors closed
10 to 14 V



NG
REPLACE BODY ECU
OK

REPLACE SUSPENSION CONTROL ECU