Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1788/88    Height Control OFF Switch Circuit

for Preparation Click here


DESCRIPTION

Height control can be operated or suspended by pressing the height control OFF switch.
By pressing the switch once, height control can be suspended.
By pressing the switch one more time, height control can be operated.

DTC No.
DTC Detecting Condition
Trouble Area
C1788/88
Height control OFF switch signal does not change.
  1. Height control OFF switch
  2. Height control OFF switch circuit
  3. Suspension control ECU

WIRING DIAGRAM


F043235E01


INSPECTION PROCEDURE

HINT:
Start the inspection from step 1 when using the intelligent tester and start from step 2 when not using the intelligent tester.

1.READ VALUE OF DATA LIST (HEIGHT SW HOLD)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON, and turn the intelligent tester main switch ON.

  1. Select the item "HEIGHT SW HOLD" in the DATA LIST, and read its value displayed on the intelligent tester.

  1. Check that the value displayed on the intelligent tester changes by pressing the height control mode select switch.

    OK:
    Height control mode select switch value changes.



OK
REPLACE SUSPENSION CONTROL ECU
NG


2.INSPECT HEIGHT CONTROL OFF SWITCH


    C123983E02
  1. Disconnect the height control OFF switch connector.

  1. Check continuity between terminals 3 and 4 of the height control mode select switch when the height control OFF switch is pushed in and free.

    Standard resistance:
    Switch condition
    Specified condition
    Pushed in
    Below 1 Ω
    Free
    10 kΩ or higher



NG
REPLACE HEIGHT CONTROL OFF SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (HEIGHT CONTROL OFF SWITCH - SUSPENSION CONTROL ECU)
  1. Check for open and short circuit in the harness and the connector between the height control OFF switch and the suspension control ECU (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU