Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

DTC    C1786/86    Height Control Switch Circuit

for Preparation Click here


DESCRIPTION

Vehicle height can be chosen by pressing the height control switch.
By pressing the "UP" side, vehicle height goes up.
By pressing the "DOWN" side, vehicle height goes down.

DTC No.
DTC Detecting Condition
Trouble Area
C1786/86
Height control switch signal does not change.
  1. Height control switch
  2. Height control switch circuit
  3. Suspension control ECU

WIRING DIAGRAM


F043234E01


INSPECTION PROCEDURE

HINT:
Start the inspection from step 1 when using the intelligent tester and start from step 2 when not using the intelligent tester.

1.READ VALUE OF DATA LIST (HEIGHT SW DOWN AND HEIGHT SW UP)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON, and turn the intelligent tester main switch ON.

  1. Select the item "HEIGHT SW DOWN" or "HEIGHT SW UP" in the DATA LIST, and read its value displayed on the intelligent tester.

  1. Check that the value displayed on the intelligent tester changes by pressing the height control switch "UP" or "DOWN".

    OK:
    Height control switch value changes.



OK
REPLACE SUSPENSION CONTROL ECU
NG


2.INSPECT HEIGHT CONTROL SWITCH


    F043252E01
  1. Remove the height control switch connector.

  1. Check continuity between each terminal of the height control switch when the height control switch "UP" or "DOWN" button is pressed.

    Standard resistance:
    Tester connection
    Switch condition
    Specified condition
    2 - 3
    "UP" button
    Below 1 Ω
    2 - 3
    "DOWN" button
    10 kΩ or higher
    2 - 4
    "UP" button
    10 kΩ or higher
    2 - 4
    "DOWN" button
    Below 1 Ω



NG
REPLACE HEIGHT CONTROL SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (HEIGHT CONTROL SWITCH - SUSPENSION CONTROL ECU)
  1. Check for open and short circuit in the harness and the connector between the height control switch and the suspension control ECU (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU