Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

HINT:
Click here.



2. DISCONNECT BATTERY NEGATIVE TERMINAL


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL COVER LOWER NO. 3


5. REMOVE STEERING WHEEL COVER LOWER NO. 2


6. REMOVE HORN BUTTON ASSEMBLY

NOTICE:
If the airbag connector is disconnected with the ignition switch being at ON, DTCs will be recorded.



    F043322E01
  1. Using a "torx" socket wrench ("Torx" socket wrench (T=30)), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    F043321E01
  1. Pull out the steering pad from the steering wheel assembly.

    NOTICE:
    When removing the steering pad, take care not to pull the airbag wire harness.

  1. Using a screwdriver, release the lock part of each of the airbag connectors and disconnect the 2 airbag connectors.

  1. Disconnect the horn ground harness from the steering pad.



    F043311E01
  1. Remove the steering pad.

    CAUTION:
    1. When storing the steering pad, keep the upper surface of the pad facing upward.
    2. Never disassemble the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY


    F043320E01
  1. without Steering pad switch:
    Disconnect the connector.

  1. Remove the steering wheel assembly set nut.

  1. Mark matchmarks on the steering wheel assembly and main shaft assembly.

  1. Set the SST on the steering wheel assembly.

  1. Holding the SST to the monkey spanner and turn the SST, then remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE STEERING COLUMN COVER UPR


9. REMOVE SPIRAL CABLE SUB-ASSEMBLY


    H042178
  1. Disconnect the 2 connectors.

  1. Remove the 4 screws and spiral cable.



10. REMOVE TURN SIGNAL SWITCH ASSEMBLY


    F043318
  1. Disconnect the 3 connectors.

  1. Remove the 3 screws and turn signal switch assembly.



11. REMOVE STEERING SENSOR


    C088509
  1. Remove the steering sensor connector.



    C088506
  1. Remove the 2 claws, then remove the steering sensor.