Home › BODY › EXTERIOR › REAR SPOILER

REAR SPOILER > REMOVAL

for Preparation Click here



1. REMOVE REAR SPOILER


    B063789
  1. Remove the 2 grommets, 2 bolts and spoiler.

  1. Disconnect the center stop light connector.



2. REMOVE CENTER STOP LIGHT ASSEMBLY


    B063787
  1. Remove the 2 bolts and stop light assembly.



3. REMOVE REAR SPOILER CLIP NO. 1


    B064660E01
  1. Use a drill which tip is less than φ 4 mm (0.16 in.).

  1. Tape the drill tip as shown in the illustration.

    Dimension (A):
    5 mm (0.20 in.)

    HINT:
    In order not to drill too deeply, tape the drill tip.

  1. Gently and vertically place the drill tip onto the rivet, cut the rivet flanges, and then remove the rivet.

    NOTICE:
    1. Placing the drill tip strongly will turn the rivet together with the drill, and so the rivet will not be cut.
    2. Prizing the hole with a drill can lead to damage to the rivet hole or the drill itself.
    3. Be careful in undertaking this task as the cut rivet is hot.

  1. Remove the 2 spoiler clips from the back door panel.