Home › BODY › SEAT › SEAT HEATER CONTROL

SEAT HEATER CONTROL > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT HEATER CONTROL LH
  1. Disconnect the seat heater control LH connector.



    B031234E03
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    6 - Body ground
    Constant
    Below 1 Ω
    1 - 6
    (Seat heater switch)
    OFF → ON
    0 V → 10 to 14 V
    4 - 6
    Constant
    10 to 14 V

    If the result is not as specified, there may be a malfunction on the wire harness side or seat heater switch.



2. INSPECT FRONT SEAT HEATER CONTROL RH
  1. Disconnect the seat heater control RH connector.



    B031234E03
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    6 - Body ground
    Constant
    Below 1 Ω
    1 - 6
    (Seat heater switch)
    OFF → ON
    0 V → 10 to 14 V
    4 - 6
    Constant
    10 to 14 V

    If the result is not as specified, there may be a malfunction on the wire harness side or seat heater switch.