Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > INSPECTION

for Preparation Click here



1. INSPECT BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust or scoring.



2. INSPECT PAD LINING THICKNESS


    F042679
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    11.5 mm (0.453 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)



3. INSPECT DISC THICKNESS


    F042680
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    28.0 mm (1.102 in.)

    Minimum thickness:
    26.0 mm (1.024 in.)



4. INSPECT DISC RUNOUT


    F043106
  1. Temporarily fasten the disc with hub nuts.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }

  1. Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the disc.

    Maximum disc runout:
    0.05 mm (0.0020 in.)

  1. If the disc runout is maximum value or greater, check the bearing play in the axial direction and check the axle hub runout . If the bearing play and axle hub runout are normal, adjust the disc runout or grind it on a "On-car" brake lathe.