Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > REMOVAL

for Preparation Click here


HINT:
Overhaul procedure of the RH side is the same as that of with LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off the brake fluid immediately if it comes into contact with a painted surface.



3. REMOVE FRONT DISC BRAKE ANTIRATTLE W/HOLE PIN


    F043185
  1. Remove the 2 pin hole clips, then remove the 2 anti-rattle w/ hole pins from disc brake cylinder assembly.

  1. Remove the anti-rattle spring from the disc brake pad.



4. REMOVE DISC BRAKE PAD KIT FRONT (PAD ONLY)
  1. Remove the 2 disc brake pads with anti-squeal shim from the disc brake cylinder assembly.



5. REMOVE ANTI SQUEAL SHIM KIT FRONT
  1. Remove the 2 anti-squeal shims from each of the disc brake pads.



6. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


    F043120
  1. Using SST, disconnect the brake tube from the disc brake cylinder assembly.

    SST
    09023-00101  

    HINT:
    Use a container to each brake fluid as it drains out.



    F043121
  1. Remove the 2 bolts and remove the disc brake cylinder assembly.