Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    F043024
  1. Using a screwdriver, remove the 4 cylinder boots from the caliper.



2. REMOVE FRONT DISC BRAKE PISTON


    F042676E03
  1. Prepare the wooden plate to hold the pistons.



    F042677
  1. Place the plate between the pistons and insert a pad at one side.

  1. Use compressed air to remove the pistons alternately from the cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.



3. REMOVE PISTON SEAL


    F042678
  1. Using a screwdriver, remove the 4 piston seals from the cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the breeder plug cap and breeder plug from the disc brake cylinder assembly.



5. INSPECT BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust or scoring.



6. INSPECT PAD LINING THICKNESS


    F042679
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    11.5 mm (0.453 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)



7. INSPECT DISC THICKNESS


    F042680
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    28.0 mm (1.102 in.)

    Minimum thickness:
    26.0 mm (1.024 in.)



8. REMOVE FRONT DISC
  1. Make matchmarks on the disc and the axle hub.

  1. Remove the front disc.