Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT DISC
  1. Aligning the matchmarks, install the front disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the minimum runout.



2. INSPECT DISC RUNOUT


    F043106
  1. Temporarily fasten the disc with hub nuts.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }

  1. Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the disc.

    Maximum disc runout:
    0.05 mm (0.0020 in.)

  1. If the disc runout is maximum value or greater, check the bearing play in the axial direction and check the axle hub runout . If the bearing play and axle hub runout are normal, adjust the disc runout or grind it on a "On-car" brake lathe.



3. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
  1. Temporarily tighten the bleeder plug to the disc brake cylinder assembly.

  1. Install the breeder plug cap to the breeder plug.



4. INSTALL PISTON SEAL
  1. Apply the lithium soap base glycol grease to the 4 new piston seals.

  1. Install the 4 piston seals to the disc brake cylinder assembly.



5. INSTALL FRONT DISC BRAKE PISTON
  1. Apply the lithium soap base glycol grease to the 4 disc brake pistons.

  1. Install the 4 disc brake pistons on the disc brake cylinder assembly.

    NOTICE:
    Do not screw the disc brake piston forcedly in the disc brake cylinder assembly.



6. INSTALL CYLINDER BOOT
  1. Apply the lithium soap grease glycol grease to the 4 new cylinder boots.

  1. Install the 4 cylinder boots on the disc brake cylinder assembly.

    HINT:
    Install the cylinder boot securely on the grooves of the disc brake cylinder and piston.