Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > INSPECTION

for Preparation Click here



1. INSPECT BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust or scarring.



2. INSPECT PAD LINING THICKNESS


    F043130
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    10.0 mm (0.394 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)



3. INSPECT REAR DISC BRAKE PAD SUPPORT PLATE
  1. Inspect the 4 pad support plates. Make sure the plates have sufficient rebound check for deformation, cracks or wear, rust, dirt or foreign particles.



4. INSPECT DISC THICKNESS


    F043131
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    18.0 mm (0.709 in.)

    Minimum thickness:
    16.0 mm (0.630 in.)



5. INSPECT DISC RUNOUT


    F043187
  1. Temporarily fasten the disc with hub nuts.

    Torque:
    110 N*m{ 1,122 kgf*cm , 81 ft.*lbf }

  1. Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the disc.

    Maximum disc runout:
    0.20 mm (0.0079 in.)

  1. If the disc runout is the maximum value or greater, check the bearing play in the axial direction and check the axle hub runout . If the bearing play and axle hub runout are normal, adjust the disc runout or grind it on a "On-car" brake lathe.