Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    F043127
  1. Using a screwdriver, remove the cylinder boot from disc brake cylinder assembly rear.



2. REMOVE REAR DISC BRAKE PISTON


    F043128
  1. Place a of cloth or equivalent between the piston and the disc brake cylinder assembly rear.

  1. Use compressed air to remove the piston from the disc brake cylinder assembly rear.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter the brake fluid.



3. REMOVE PISTON SEAL


    F043129
  1. Using a screwdriver, remove the piston seal from the disc brake cylinder assembly rear.



4. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from disc brake cylinder assembly rear.



5. INSPECT BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust or scarring.



6. INSPECT PAD LINING THICKNESS


    F043130
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    10.0 mm (0.394 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)



7. INSPECT REAR DISC BRAKE PAD SUPPORT PLATE
  1. Inspect the 4 pad support plates. Make sure the plates have sufficient rebound check for deformation, cracks or wear, rust, dirt or foreign particles.



8. INSPECT DISC THICKNESS


    F043131
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    18.0 mm (0.709 in.)

    Minimum thickness:
    16.0 mm (0.630 in.)



9. REMOVE REAR DISC
  1. Make matchmarks on the rear disc and the axle hub.

  1. Remove the rear disc.