Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > ADJUSTMENT

for Preparation Click here



1. CHECK BRAKE PEDAL HEIGHT


    F043109E02
  1. Check the brake pedal height.

    Pedal height from dash panel:
    166.1 to 176.1 mm (6.539 to 6.933 in.)

    NOTICE:
    Do not adjust the pedal height. Doing so by changing the push rod length will structurally change the pedal ratio.

    If the pedal height is incorrect, adjust the rod operating adapter length.



    F044242E02
  1. Adjust the rod operating adapter length.

    1. Remove the clip and clevis pin.

    2. Loosen the clevis lock nut.

    3. Adjust the rod operating adapter length by turning the pedal push rod clevis.

      Rod operating adapter length "A":
      232.5 to 242.5 mm (9.154 to 9.547 in.)

    4. Tighten the clevis lock nut.

      Torque:
      26 N*m{ 265 kgf*cm , 19 ft.*lbf }

    5. Install the clip and clevis pin.
      If the pedal height is incorrect even if the rod operating adapter is adjusted, check that there is no damage in brake pedal, brake pedal lever, brake pedal bracket and dash panel.

      1. Even if there is damage, there is no problem if the reserve distance is within the standard value.
      2. If necessary, replace them.



2. CHECK AND ADJUST STOP LIGHT SWITCH ASSEMBLY

HINT:
If the pedal height is incorrect, check and adjust the stop light switch clearance.

  1. Disconnect the stop light switch assembly connector from the stop light switch assembly.

  1. Turn the stop light switch assembly counterclockwise and remove the stop light switch assembly.



    F043108E12
  1. Insert the stop light switch assembly until the body hits the cushion.

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

  1. Make a quarter turn clockwise to install the stop light switch assembly.

    NOTICE:
    The turning torque for installing the stop light switch assembly.

    HINT:
    Due to the inverse screw structure, if the stop light switch assembly is turned clockwise, the stop light switch assembly moves in the direction to be pulled out.

  1. Connect the stop light switch connector to the stop light switch assembly.

  1. Check the protrusion of the rod.

    Protrusion of the rod:
    0.5 to 2.5 mm (0.020 to 0.098 in.)

  1. Install the clevis pin and clip.

  1. After adjusting the pedal height, check the pedal free play.



3. CHECK PEDAL FREE PLAY


    F043110E01
  1. Stop the engine and depress the brake pedal several times until there is no more vacuum left in the booster.

  1. Push in the pedal until the beginning of the resistance is felt. Measure the distance, as shown.

    Pedal free play:
    1 to 6 mm (0.04 to 0.24 in.)



4. CHECK PEDAL RESERVE DISTANCE


    R000934E23
  1. Release the parking brake pedal.
    With engine running, depress the pedal and measure the pedal reserve distance, as shown.

    Pedal reserve distance from asphalt sheet at 490 N (50 kgf, 110.2 lbf):
    More than 55 mm (2.17 in.)

    If incorrect, troubleshoot the brake system.