Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISPOSAL

for Preparation Click here


HINT:
Dispose the RH side by the same procedures with the LH side.



1. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH (w/o REAS)


    G021673E01
  1. Fully extend the shock absorber piston rod, and fix it at a tilt in a vise or similar tool.

  1. Using a drill or similar tool, slowly make a hole at approx. 5 cm from the top end of the shock absorber, and discharge the gas inside of it.

    CAUTION:
    1. The gas is colorless, odorless and harmless.
    2. Since the discharged gas may cause chips to fly off, cover the drill with a shop rag when making a hole.



2. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH (w/ REAS)


    G022707
  1. Before the disposal, loosen the nut slowly to breed out the oil and to lower the pressure inside the absorber.

    NOTICE:
    Never loosen the nut of the eye union except the time of disposal.