Home › SUSPENSION & AXLE › SUSPENSION › FRONT SUSPENSION LOWER NO. 1 ARM

FRONT SUSPENSION LOWER NO. 1 ARM > REMOVAL

for Preparation Click here



1. REMOVE FRONT DISC WHEEL


2. INSPECT FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 LH


    G021682
  1. Install the hub nuts to the disc.

  1. Using a dial indicator, check the lower ball joint for excessive play when you push the hub nuts up and down with a force of 294 N (30 kgf, 66 lbf).

    Maximum:
    0.5 mm (0.020 in.)

    HINT:
    If it is not within the specification, replace the lower arm.



3. SEPARATE FRONT SHOCK ABSORBER WITH COIL SPRING


    C099159
  1. Remove the bolt, nut and washer.

  1. Separate the front shock absorber with coil spring from the suspension lower arm.



4. REMOVE FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 LH


    G020159
  1. Remove the 2 bolts, and separate the front lower ball joint attachment LH from the front axle.



    G020160E03
  1. Place matchmarks on the camber adjust cam No. 2 and toe adjust cam sub-assembly.

  1. Remove the nut, camber adjust cam No. 2, camber adjust cam assembly, bolt, toe adjust cam sub-assembly, toe adjust plate No. 2 and front suspension arm sub-assembly lower No. 1 LH.



    G020416E02
  1. Remove the cotter pin and the nut.

  1. Using SST, remove the front lower ball joint attachment LH.

    SST
    09628-00011  



5. REMOVE FRONT LOWER ARM BUSH NO. 1 LH


    G020164
  1. Using a hammer and a chisel, raise the flange of the bushing diagonally as shown in the illustration.



    G020412E01
  1. Using SST and a press, remove the lower arm bush No. 1 LH.

    SST
    09632-36010  
    09950-00020  
    09950-60010   (09951-00400)



6. REMOVE FRONT LOWER ARM BUSH NO. 2 LH


    G020164
  1. Using a hammer and a chisel, raise the flange of the bushing diagonally as shown in the illustration.



    G020413E01
  1. Using SST and a press, remove the lower arm bush No. 2 LH.

    SST
    09632-36010  
    09950-00020  
    09950-60010   (09951-00400)