Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL STABILIZER BAR REAR


    D028261E02
  1. Install the 2 stabilizer bushes to the stabilizer bar.

    HINT:
    Install the stabilizer bush to the inner side of the stabilizer bush stopper on the stabilizer bar.



    D028260
  1. Install the stabilizer bar and the 2 stabilizer brackets with the 4 bolts.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }



2. INSTALL REAR STABILIZER LINK ASSEMBLY


    D028258
  1. Install the stabilizer link with the nut (LH side).

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.

  1. Install the 2 retainers and the cushion to the stabilizer link.



    D028259
  1. Hold the stabilizer bar link with a wrench, and install the nut, retainer, cushion and link.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }



3. REMOVE REAR STABILIZER LINK ASSEMBLY

HINT:
Install the RH side by following the same procedures with the LH side.



4. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 83 ft.*lbf }