Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR STABILIZER LINK ASSEMBLY


    D028258
  1. Remove the nut and disconnect the stabilizer bar from the stabilizer link (LH side).

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.



    D028259
  1. Hold the stabilizer bar link with a wrench and remove the nut, retainer, cushion and link.

  1. Remove the 2 retainers and cushion from the stabilizer link.



3. REMOVE REAR STABILIZER LINK ASSEMBLY

HINT:
Remove the RH side by following the same procedures with the LH side.



4. REMOVE STABILIZER BAR REAR


    D028260
  1. Remove the 4 bolts, the 2 stabilizer brackets and the stabilizer bar.

  1. Remove the 2 stabilizer bushes from the stabilizer bar.