Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Television Display Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the television display assembly.

WIRING DIAGRAM


E119746E01


INSPECTION PROCEDURE

1.INSPECT TELEVISION DISPLAY ASSEMBLY
E113507E04
  1. Disconnect the connector from the television display assembly.

  1. Measure the resistance according to the value(s) in the table below.
    Standard resistance 
    Tester Connection
    Condition
    Specified Condition
    GND6 - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.
    Standard voltage 
    Tester Connection
    Condition
    Specified Condition
    +B2 - GND
    Always
    10 to 14 V
    ACC4 - GND
    Ignition SW ACC
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE