Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Video Terminal and Television Display

for Preparation Click here


DESCRIPTION

This is the sound signal circuit from the video (video adapter) terminal to the television display assembly.

WIRING DIAGRAM


E124110E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO TERMINAL)


    E119743E03
  1. Disconnect the connectors from the video (video adapter) terminal and television display assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    SGND - SG7
    Always
    Below 1 Ω
    AUXR - AUXR
    Always
    Below 1 Ω
    AUXL - AUXL
    Always
    Below 1 Ω
    CE - OPEN
    Always
    Below 1 Ω
    AUXR - Body ground
    Always
    10 kΩ or higher
    AUXL - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT VIDEO TERMINAL


    E110048E05
  1. Reconnect the video (video adapter) terminal connector.

  1. Using an oscilloscope, check the signal waveform between each terminal and body ground according to the conditions, as shown in the chart.

    HINT:
    An external device system is playing (When the video (video adapter) terminal is used).

    Signal waveform:
    Tester Connection
    Condition
    Specified Condition
    AUXL - Body ground
    Sound is being produced
    A waveform synchronized with sound is output
    AUXR - Body ground
    Sound is being produced
    A waveform synchronized with sound is output



NG
REPLACE VIDEO TERMINAL
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE