NAVIGATION SYSTEM > Radio Broadcast cannot be Received or Poor Reception |
| 1.CHECK RADIO AND NAVIGATION ASSEMBLY |
Check the radio's automatic station search function.
Check the radio's automatic station search function by activating it.
|
| ||||
| NG | |
| 2.INSPECT RADIO AND NAVIGATION ASSEMBLY |
![]() |
Disconnect the radio and navigation assembly connector R12.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ANT - Body ground | Ignition SW ON Radio SW ON | 10 to 14 V |
|
| ||||
| OK | |
| 3.CHECK OPTIONAL COMPONENTS |
Check optional components (sun-shade film, telephone antenna, etc.).
Check if any optional components, such as sunshade film or telephone antenna that may decrease reception capacity, are installed.
|
| ||||
| NG | |
| 4.CHECK RADIO AND NAVIGATION ASSEMBLY |
![]() |
Preparation for check
Remove the antenna plug from the radio and navigation assembly.
Check for noise
Turn the ignition switch to the ACC position with the radio and navigation assembly connector connected.
Turn the radio on and put into AM mode.
Place a screwdriver, thin wire, or other metal object on the radio receiver's antenna jack and check that noise can be heard from the speaker.
|
| ||||
| OK | |
| 5.CHECK GLASS ANTENNA |
![]() |
Check for continuity of the antenna.
|
| ||||
| OK | |
| 6.REPLACE ANTENNA AMPLIFIER |
Replace the antenna amplifier and check that it operates normally.
|
| ||||
| NG | ||
| ||