Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Speaker Circuit

for Preparation Click here


DESCRIPTION

The sound signal that has been amplified by the stereo component amplifier is sent to the speakers from the stereo component amplifier through this circuit.
If there is a short in this circuit, the stereo component amplifier detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier or speakers.
When a short is detected in the speaker circuit, no sound can be heard from the speakers.

WIRING DIAGRAM


E121189E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR


    E121190E01
  1. Disconnect the connectors shown in the illustration on the left from the stereo component amplifier and speakers.

  1. Measure the resistance between the front No. 2 speakers and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between rear speakers and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between the front stereo component speaker and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between the woofer box speaker and the stereo component amplifier to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between the front No. 1 speaker and the front No. 2 speaker to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between each speaker and body ground to check for a short circuit in the wire harness.

    Standard resistance:
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT WOOFER BOX SPEAKER


    E120044
  1. Resistance check.

  1. Measure the resistance according to the value(s) in the table below.

    NOTICE:
    The speaker should not be removed for checking.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    1 - 3
    Always
    Approximately 1.2 Ω
    2 - 4
    Always
    Approximately 1.2 Ω



NG
REPLACE WOOFER BOX SPEAKER
OK


3.INSPECT FRONT NO. 1 SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      4 to 6 Ω



NG
REPLACE FRONT NO. 1 SPEAKER
OK


4.INSPECT FRONT NO. 2 SPEAKER
  1. Check that the malfunction disappears when another speaker in good condition is installed.

    OK:
    Malfunction disappears.

    HINT:
    1. Connect all the connectors to the front No. 2 speakers.
    2. When there is a possibility that either right or left front speaker is defective, inspect by interchanging the right one with the left one.



OK
REPLACE FRONT NO. 2 SPEAKER
NG


5.INSPECT REAR SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Approximately 2.6 Ω



NG
REPLACE REAR SPEAKER
OK


6.INSPECT FRONT STEREO COMPONENT SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      1.2 to 2.2 Ω



NG
REPLACE FRONT STEREO COMPONENT SPEAKER
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE