Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Radio and Navigation Assembly Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the radio and navigation assembly.

WIRING DIAGRAM


E121223E05


INSPECTION PROCEDURE

1.INSPECT RADIO AND NAVIGATION ASSEMBLY


    E113513E04
  1. Disconnect the radio and navigation assembly connector R12.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    GND - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    B - GND
    Always
    10 to 14 V
    ACC - GND
    Ignition SW ACC
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE