Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Microphone and Radio and Navigation Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone to the radio and navigation assembly.
It also supplies power from the radio and navigation assembly to the microphone.

WIRING DIAGRAM


E121194E02


INSPECTION PROCEDURE

1.INSPECT RADIO AND NAVIGATION ASSEMBLY


    E121195E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    MACC - Body ground
    Ignition SW ACC
    4 to 6 V



NG
REPLACE RADIO AND NAVIGATION ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR


    E113512E02
  1. Disconnect the radio and navigation assembly connector R26.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    SGND - TSW-
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO AND NAVIGATION ASSEMBLY)


    E121196E01
  1. Disconnect the microphone connector T18 and radio and navigation assembly connector R26.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    ACC - MACC
    Always
    Below 1 Ω
    MIC+ - MIC+
    Always
    Below 1 Ω
    MIC- - MIC-
    Always
    Below 1 Ω
    MACC - Body ground
    Always
    10 kΩ or higher
    MIC+ - Body ground
    Always
    10 kΩ or higher
    MIC- - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE