Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Radio and Navigation Assembly and Television Display Assembly

for Preparation Click here


DESCRIPTION

The television display assembly sends an RSE sound signal to the radio and navigation assembly through this circuit. The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio and navigation assembly or speakers.

WIRING DIAGRAM


E120034E05


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)


    E121191E03
  1. Disconnect the connectors from the television display assembly and radio and navigation assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    CDR+ - R+
    Always
    Below 1 Ω
    CDR- - R-
    Always
    Below 1 Ω
    CDL+ - L+
    Always
    Below 1 Ω
    CDL- - L-
    Always
    Below 1 Ω
    CSLD - SG1
    Always
    Below 1 Ω
    R- - Body ground
    Always
    10 kΩ or higher
    L+ - Body ground
    Always
    10 kΩ or higher
    L- - Body ground
    Always
    10 kΩ or higher
    R+ - Body ground
    Always
    10 kΩ or higher
    SG1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY


    E120036E07
  1. Reconnect the television display assembly connector and radio and navigation assembly connectors.

  1. Check the waveform according to the conditions in the table below.

    Standard resistance:

    Tester connection
    Condition
    Specified condition
    R+ - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output
    R- - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output
    L+ - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output
    L- - Body ground
    Voice sound is being produced
    A waveform synchronized with sound is output



NG
REPLACE TELEVISION DISPLAY ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE