Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Display Signal Circuit between Television Display Assembly and Radio and Navigation Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a DVD image signal from the television display assembly to the radio and navigation assembly.

WIRING DIAGRAM


E121197E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)


    E121198E02
  1. Disconnect the radio and navigation assembly connector R27 and television display assembly connector R18.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    VV+ - NTS1
    Always
    Below 1 Ω
    VV- - SG3
    Always
    Below 1 Ω
    VV+ - Body ground
    Always
    10 kΩ or higher
    VV- - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY


    E113508E02
  1. Reconnect the television display assembly connector R18.

  1. Measure the waveform according to the table below.

    OK:
    Tester connection
    Condition
    Specified condition
    VV+ - Body ground
    DVD display is ON
    A waveform synchronized with display signals is output

    HINT:
    The waveform pattern may differ from that shown in the illustration below due to differences in oscilloscope setting. A normal television display assembly operating condition can be determined if any waveform is output.



    E111833E02
  1. Oscilloscope waveform

    1. Terminal: VV+ - Body ground
      Setting: 200 mV/DIV., 10 μs/DIV.
      Condition: DVD display is ON.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE