NAVIGATION SYSTEM > Mute Signal Circuit between Radio and Navigation Assembly and Television Display Assembly |

| 1.INSPECT TELEVISION DISPLAY ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| LMUT - Body ground | Turn ignition switch to ACC, RSE system is playing → Changing mode | Above 3.5 V → Below 1 V |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION DISPLAY ASSEMBLY) |
![]() |
Disconnect the radio and navigation assembly connector R11 and television display assembly connector R18.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| MUTE - LMUT | Always | Below 1 Ω |
| MUTE - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE TELEVISION DISPLAY ASSEMBLY |
Replace the television display assembly and check if it operates normally.
|
| ||||
| NG | ||
| ||