NAVIGATION SYSTEM > Vehicle Speed Signal Circuit between Radio and Navigation Assembly and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
|
| ||||
| OK | |
| 2.INSPECT RADIO AND NAVIGATION ASSEMBLY |
![]() |
Disconnect the radio and navigation assembly connector R9.
Measure the voltage.
Jack up either one of the drive wheels.
Move the shift lever to the neutral position.
Turn the ignition switch to the ON position.
![]() |
Measure the voltage between terminal SPD of the radio and navigation assembly and body ground when the drive wheels are turned slowly.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - RADIO AND NAVIGATION ASSEMBLY) |
![]() |
Disconnect the radio and navigation assembly connector R9 and combination meter connector C9.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| SPD - C9-5 | Ignition switch off | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - RADIO AND NAVIGATION ASSEMBLY) |
![]() |
Disconnect the radio and navigation assembly connector R9 and combination meter connector C9.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| SPD - Body ground | Ignition switch off | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||