AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Television Display Assembly |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - TELEVISION DISPLAY ASSEMBLY) |
![]() |
Disconnect the connectors from the television display assembly and radio receiver.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| CDR+ - R+ | Always | Below 1 Ω |
| CDR- - R- | Always | Below 1 Ω |
| CDL+ - L+ | Always | Below 1 Ω |
| CDL- - L- | Always | Below 1 Ω |
| CSLD - SG1 | Always | Below 1 Ω |
| R- - Body ground | Always | 10 kΩ or higher |
| L+ - Body ground | Always | 10 kΩ or higher |
| L- - Body ground | Always | 10 kΩ or higher |
| R+ - Body ground | Always | 10 kΩ or higher |
| SG1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT TELEVISION DISPLAY ASSEMBLY |
![]() |
Reconnect the television display assembly connector.
Check the waveform according to the conditions shown in the table below.
| Tester Connection | Condition | Specified Condition |
| R+ - Body ground | Voice sound is being produced | A waveform synchronized with sound is output |
| R- - Body ground | Voice sound is being produced | A waveform synchronized with sound is output |
| L+ - Body ground | Voice sound is being produced | A waveform synchronized with sound is output |
| L- - Body ground | Voice sound is being produced | A waveform synchronized with sound is output |
|
| ||||
| OK | ||
| ||