Home › BODY ELECTRICAL › AUDIO / VISUAL › NO. 1 SPEAKER WITH BOX

NO. 1 SPEAKER WITH BOX > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT NO. 1 SPEAKER WITH BOX

HINT:
Remove interior parts so that the No. 1 speaker with box can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the No. 1 speaker with box.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the No. 1 speaker with box.



    I034673
  1. Resistance check.

    1. Measure the resistance according tot the value(s) in the table below.

      NOTICE:
      The speaker should not be removed for checking.

      Standard resistance:
      Tester connection
      Condition
      Specified condition
      1 - 3
      Always
      Approximately 1.2 Ω
      2 - 4
      Always
      Approximately 1.2 Ω

      If the result is not as specified, replace the No. 1 speaker with box.