DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0335 |
|
|
| P0339 | Under conditions (a), (b) and (c), no CKP sensor signal to ECM for 0.05 seconds or more (1 trip detection logic): (a) Engine speed 1,000 rpm or more (b) Starter signal OFF (c) 3 seconds or more has lapsed since starter signal switched from ON to OFF |
|

| Items | Contents |
| Terminals | VV1+ - VV1- VV2+ - VV2- NE+ - NE- |
| Equipment Settings | 5 V/Division, 20 ms/Division |
| Conditions | Cranking or idling |
| Related DTCs | P0335: Crankshaft position sensor range check or rationality |
| Required Sensors / Components (Main) | Crankshaft Position sensor |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | Case 1: 0.016 seconds Case 2: 3 times |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| Engine RPM | 600 rpm or more |
| Starter | OFF |
| Time after starter ON to OFF | 3 seconds or more |
| Time after starter ON to OFF | 0.3 seconds or more |
| Number of camshaft position sensor signal pulse | 6 or more |
| Ignition switch | ON |
| Battery voltage | 7 V or more |
| Engine speed signal | No signal for 0.016 seconds |
| Number of crankshaft position sensor signal pulse | 132 or less, or 174 or more |

| 1.INSPECT CRANKSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C4 Crankshaft Position (CKP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connections | Specified Conditions |
| 1 - 2 | 1,630 Ω to 2,740 Ω at cold |
| 1 - 2 | 2,065 Ω to 3,225 Ω at hot |
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C4 CKP sensor connector.
Disconnect the E6 ECM connector.
Measure the resistance.
| Tester Connections | Specified Conditions |
| NE+ (C4-1) - NE+ (E6-21) | Below 1 Ω |
| NE- (C4-2) - NE- (E6-20) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| NE+ (C4-1) or NE+ (E6-21) - Body ground | 10 kΩ or higher |
| NE- (C4-2) or NE- (E6-20) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CRANKSHAFT POSITION SENSOR) |
![]() |
Check the CKP sensor installation.
|
| ||||
| OK | |
| 4.CHECK CRANKSHAFT POSITION SENSOR PLATE (TEETH OF SENSOR PLATE) |
Check the teeth of the sensor plate.
|
| ||||
| OK | ||
| ||