DTC P0016 Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A) |
DTC P0018 Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor A) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0016 | Deviations in crankshaft and camshaft position sensor (for intake camshaft) 1 signals (2 trip detection logic) |
|
| P0018 | Deviations in crankshaft and camshaft position sensor (for intake camshaft) 2 signals (2 trip detection logic) |
|
| Related DTCs | P0016: Deviation in crankshaft position sensor signal and camshaft position sensor signal (Bank 1) P0018: Deviation in crankshaft position sensor signal and camshaft position sensor signal (Bank 2) |
| Required Sensors / Components (Main) | VVT actuator |
| Required Sensors / Components (Related) | Camshaft position sensor, Crankshaft position sensor |
| Frequency of Operation | Once per driving cycle |
| Duration | Less than 60 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | P0011, P0012 (VVT System1-Advance, Retard), P0021, P0022 (VVT System2-Adavance, Retard), P0115, P0116, P0117, P0118 (ECT Sensor), |
| Engine RPM | 500 to 1,400 rpm |
| One of the following conditions 1 or 2 is met: | - |
| 1. VVT learning value at maximum retarded valve timing | Less than 22.5° CA |
| 2. VVT learning value at maximum retarded valve timing | More than 45.2° CA |
| 1.CHECK VALVE TIMING (CHECK FOR LOOSE AND A JUMPED TOOTH OF TIMING CHAIN) |
![]() |
Remove the cylinder head covers RH and LH.
Turn the crankshaft to align the matchmarks of the crankshaft.
Align the notch of the crankshaft pulley to the "0" position.
Check if the matchmarks of the camshaft pulley and camshaft bearing cap align.
Turn the crankshaft clockwise by 360° if the matchmarks do not align. Check if they align once again.
Confirm that the DTC output does not recur.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Clear DTCs (Click here).
Select the check mode using the tester (Click here).
Start the engine and warm it up.
Allow the engine to idle for 1 minute or more, and then drive the vehicle for 1 minute or more.
Confirm that no DTC is set, using the tester.
|
| ||||
| OK | ||
| ||