DTC P0101 Mass or Volume Air Flow Circuit Range / Performance Problem |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0101 |
| MAF meter |
| Related DTCs | P0101: Mass air flow meter rationality |
| Required Sensors / Components (Main) | Mass air flow meter |
| Required Sensors / Components (Related) | Engine speed sensor, engine coolant temperature sensor and throttle position sensor |
| Frequency of Operation | Continuous |
| Duration | 10 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | P0115, P0116, P0117, P0118 (ECT Sensor), P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (TP Sensor), P0125 (Insufficient ECT for Closed Loop), P0335 (CKP Sensor), P0340 (VVT Sensor 1, 2) |
| Engine RPM | Less than 2,000 rpm |
| MAF meter voltage | 4.9 V or less |
| ECT | 70°C (158 °F) or more |
| Engine RPM | More than 300 rpm |
| MAF meter voltage | 0.2 V or more |
| Fuel cut | OFF |
| Mass air flow meter voltage | More than 2.2 V (varies with throttle position sensor voltage) |
| Mass air flow meter voltage | Less than 0.83 V (varies with throttle position sensor voltage) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Turn the tester on.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0101 and other DTCs | A |
| P0101 | B |
|
| ||||
| A | ||
| ||