DTC P0500 Vehicle Speed Sensor "A" |

| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0500 | The ECM detects following conditions simultaneously 500 times (2 trip detection logic)
|
|
| Related DTCs | P0500: Vehicle speed sensor "A" pulse input error |
| Required Sensors / Components (Main) | Vehicle Speed Sensor |
| Required Sensors / Components (Related) | Park/neutral Position switch, Engine Coolant Temperature sensor, Combination meter |
| Frequency of Operation | Continuous |
| Duration | 2 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | - |
| Vehicle speed is 5.59 mph (9 km/h) or more | 4 seconds or more |
| Park/neutral position switch | OFF |
| Ignition switch | ON |
| Sensor signal | No input |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the operation of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.INSPECT ECM (SPD VOLTAGE) |
![]() |
Shift the shift lever to the neutral position.
Jack up the vehicle.
Turn the ignition switch on.
Check the voltage between the terminals of the E6 and E7 ECM connectors as the wheel is turned slowly.
| Tester Connections | Specified Conditions |
| SPD (E7-8) - E1 (E6-1) | Voltage generated intermittently |
|
| ||||
| OK | ||
| ||