DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2102 | Conditions (a) and (b) continue for 2.0 seconds (1 trip detection logic): (a) Throttle actuator duty ratio 80% or more (b) Throttle actuator current is 0.5 A or less |
|
| P2103 | Either of following conditions met:
|
|
| Related DTCs | P2102: Throttle actuator control motor current (low current) P2103: Throttle actuator control motor current (high current) |
| Required Sensors / Components (Main) | Throttle actuator |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | P2102: 2 seconds P2103: 0.6 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| Throttle motor | ON |
| Duty-cycle ratio to open throttle actuator | 80 % or more |
| Throttle actuator power supply | 8 V or more |
| Current motor current - Motor current at 0.016 sec. before | Less than 0.2 A |
| Throttle motor | ON |
| Either of the following conditions is met: | Condition 1 or 2 |
| 1. Throttle actuator power supply | 8 V or more |
| 2. Throttle actuator power | ON |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Throttle actuator current | Less than 0.5 A (when motor drive duty 80 % or more) |
| Either of the following conditions is met | Condition 1 or 2 |
| 1. Hybrid IC diagnosis signal | Fail |
| 2. Hybrid IC current limiter port | Fail for |

| 1.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (RESISTANCE OF THROTTLE CONTROL MOTOR) |
![]() |
Disconnect the T2 throttle with motor body connector.
Measure the resistance between the terminals of the throttle control motor.
| Tester Connections | Specified Conditions |
| M+ (T2-2) - M- (T2-1) | 0.3 to 100 Ω at 20°C (68°F) |
Reconnect the throttle with motor body connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE CONTROL MOTOR - ECM) |
![]() |
Disconnect the T2 throttle with motor body connector.
Disconnect the E4 ECM connector.
Measure the resistance.
| Tester Connections | Specified Conditions |
| M+ (T2-2) - M+ (E4-5) | Below 1 Ω |
| M- (T2-1) - M- (E4-4) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| M+ (T2-2) or M+ (E4-5) - Body ground | 10 kΩ or higher |
| M- (T2-1) or M- (E4-4) - Body ground | 10 kΩ or higher |
Reconnect the throttle with motor body connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||