DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2118 | Open in ETCS power source (+BM) circuit (1 trip detection logic) |
|
| Related DTCs | P2118: Throttle actuator motor power supply line range check (Low voltage) |
| Required Sensors / Components (Main) | Throttle actuator, throttle valve, ETCS fuse |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.8 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| Actuator power | ON |
| Battery voltage | More than 8 V |
| Throttle actuator power supply voltage | Less than 4 V |
| Throttle actuator power supply voltage | 9 to 14 V |

| 1.CHECK FUSE (ETCS FUSE) |
![]() |
Remove the ETCS fuse from the engine room R/B.
Check the ETCS fuse resistance.
Reinstall the ETCS fuse.
|
| ||||
| OK | |
| 2.INSPECT ECM (+BM VOLTAGE) |
![]() |
Measure the voltage between the terminals of the E6 and E8 ECM connectors.
| Tester Connections | Specified Conditions |
| +BM (E8-7) - E1 (E6-1) | 9 to 14 V |
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Check the harness and connector between the ETCS fuse and ECM.
Remove the ETCS fuse from the engine room R/B.
Disconnect the E8 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| ETCS fuse (2) - +BM (E8-7) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| ETCS fuse (2) or +BM (E8-7) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Check the harness and connector between the ETCS fuse and positive battery cable.
Disconnect the negative battery cable.
Check the resistance.
| Tester Connections | Specified Conditions |
| Positive battery cable - ETCS fuse (1) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| Positive battery cable or ETCS fuse (1) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the negative battery cable.
|
| ||||
| OK | ||
| ||