DTC P2119 Throttle Actuator Control Throttle Body Range / Performance |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P2119 | Throttle valve opening angle continues to vary greatly from target opening angle (1 trip detection logic) |
|
| Related DTCs | P2119: Electronic throttle control system failure |
| Required Sensors / Components (Main) | Throttle actuator |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| System guard* | ON |
| *System guard is ON when following conditions are set: | - |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor | Fail determined |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 4 V or more |
| Throttle actuator | Fail determined |
| Either of the following conditions is set: | Condition 1 or 2 |
| 1. Commanded closed throttle position - current closed throttle position | 0.3 V or more |
| 2. Commanded open throttle position - current open throttle position | 0.3 V or more |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Turn the tester on.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P2119 | A |
| P2119 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK WHETHER DTC OUTPUT RECURS (DTC P2119) |
Connect the intelligent tester to the DLC3 (Procedure "A").
Turn the ignition switch on (Procedure "B").
Turn the tester on (Procedure "C").
Clear DTCs (Click here) (Procedure "D").
Allow the engine to idle for 15 seconds (Procedure "E").
Securely apply the parking brake and move the gear selector lever to the D position (Procedure "F").
While depressing the brake pedal securely, fully depress the accelerator pedal for 5 seconds (Procedure "G").
Select the following menu items on the tester: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES (Procedure "H").
Read DTCs (Procedure "I").
|
| ||||
| OK | ||
| ||