Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0630    VIN not Programmed or Mismatch - ECM / PCM

for Preparation Click here


DESCRIPTION

DTC P0630 is set when the Vehicle Identification Number (VIN) is not stored in the Engine Control Module (ECM) or the input VIN is not accurate. Input the VIN with the intelligent tester.

DTC No.
DTC Detection Conditions
Trouble Areas
P0630
  1. VIN not stored in ECM
  2. Input VIN in ECM not accurate
ECM

MONITOR STRATEGY


Related DTCs
P0630: VIN not programmed
Required Sensors / Components (Main)
ECM
Required Sensors / Components (Related)
-
Frequency of Operation
Continuous
Duration
0.5 seconds
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever these DTCs are not present
None
Battery voltage
8 V or more
Ignition switch
ON
Ignition switch
OFF

TYPICAL MALFUNCTION THRESHOLDS


VIN code
Not programmed

COMPONENT OPERATING RANGE


VIN code
Programmed

INSPECTION PROCEDURE

1.READ CURRENT DTC
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on and turn the tester on.

  1. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.

  1. Read DTCs.

    Result:

    Display (DTC Output)
    Proceed to
    P0630
    A
    P0630 and other DTCs
    B

    If any DTCs other than P0630 are output, troubleshoot those DTCs first.

    NOTICE:
    If P0630 is set, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the tester when inputting the VIN. If DTCs other than P0630 are set, check them first.



B
GO TO DTC CHART
A


2.INPUT VIN WITH INTELLIGENT TESTER

HINT:
Refer to "REGISTRATION" (Click here).


NEXT


3.READ CURRENT DTC
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on and turn the tester on.

  1. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.

  1. Read DTC again.

    Result:
    DTC is not output (P0630).



NG
REPLACE ECM
OK

END