Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
According to the DATA LIST displayed by the intelligent tester, you can read the value of the switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as a first step of troubleshooting is one of the methods to shorten the labor time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. According to the display on tester, read the "DATA LIST".

    Item
    Measurement Item/Display (Range)
    Normal condition
    Diagnostic note
    WIPER TURN SW
    Rear wiper turn position switch signal/ON or OFF
    ON: Rear wiper is turning position
    OFF: Rear wiper is other position
    -
    WIPER RTRCT SW
    Rear wiper retracting switch signal/ON or OFF
    ON: Rear wiper is retract position
    OFF: Rear wiper is other position
    -
    WIPER STOP POS
    Rear wiper stop position signal/ON or OFF
    ON: Rear wiper is stop position
    OFF: Rear wiper is other position
    -


ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the intelligent tester allows the relay, VSV, actuator and so on to operate without parts removal. Performing the ACTIVE TEST as a first step of troubleshooting is one of the methods to shorten the labor time.
It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. According to the display on tester, perform the "ACTIVE TEST".

    Item
    Test Details
    Diagnostic Note
    REAR WIPER
    Rear wiper ON/OFF
    -