Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WIPER ARM HEAD CAP


    I033031
  1. Using a small screwdriver, remove the 2 front wiper arm head cap.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FR WIPER ARM RH
  1. Operate the wiper and stop the windshield wiper motor assembly at the automatic stop position.

  1. Remove a nut and FR wiper arm RH.



3. REMOVE FR WIPER ARM LH
  1. Remove a nut and FR wiper arm LH.



4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    I033032E02
  1. Remove the clip.

  1. Release the 2 claws, and remove the front fender to cowl side seal LH.



5. REMOVE FRONT FENDER TO COWL SIDE SEAL RH


6. REMOVE COWL TOP VENTILATOR LOUVER SUB- ASSEMBLY


    I033033E01
  1. Remove the 2 clips.

  1. Using a clipremover, disengage the meshing of 6 clips.



    I033034E01
  1. Remove the 9 claws and cowl top ventilator louver sub-assembly.



7. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    I033035
  1. Disconnect the connector and remove the 2 bolts.

  1. Slide the wiper link assembly to vehicle's passenger's side. Disengage the meshing of the rubber pin and remove the wiper link assembly.



8. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E066043
  1. Using a screwdriver and disengage the meshing of 2 rods at the clank arm pivot of the windshield wiper motor assembly.

    HINT:
    Tape the screwdriver tip before use.



    I033038
  1. Remove the 2 bolts and windshield wiper motor assembly.