Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR TRIM BOARD


    B062858E01
  1. Remove the assist strap hole cover.

  1. Remove the screw and assist strap.

  1. Using a screwdriver, remove the back door trim cover.

    HINT:
    Tape the screwdriver tip before use.
    In order to prevent the back door from being damaged, cover the parts indicated by arrow marks in the illustration with tape.

  1. Using a clip remover, remove the 10 clips and trim board.

  1. Remove the inner weatherstrip.



2. REMOVE BACK DOOR SERVICE HOLE COVER LH


    B062865E02
  1. Remove the back door service hole cover LH.

    NOTICE:
    Remove the remaining tape on the back door side.



3. REMOVE REAR WIPER ARM HEAD CAP


    I033023E01
  1. Release the 4 claws and remove the rear wiper arm head cap.



4. REMOVE REAR WIPER ARM
  1. Remove a nut and rear wiper arm.



5. REMOVE REAR WIPER MOTOR GROMMET


6. REMOVE REAR WIPER MOTOR ASSEMBLY


    I033024
  1. Remove the 2 grommets.



    I033025
  1. Remove the 3 bolts.



    I033026
  1. Using a clipremover, remove the clamp.

  1. Disconnect the connector and remove the rear wiper motor assembly.