Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Relay Circuit

for Preparation Click here


WIRING DIAGRAM


E064840E01


INSPECTION PROCEDURE

1.INSPECT HEADLIGHT RELAY


    E064835
  1. Check the continuity of the headlight relay.

    Standard:
    Condition
    Tester connection
    Specified condition
    Constant
    1 - 2
    Continuity
    Constant
    3 - 5
    No continuity
    Apply B+ between terminal 1 and 2
    3 - 5
    Continuity



NG
REPLACE HEADLIGHT RELAY
OK


2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (HEAD)


    I033101
  1. Inspect light control switch continuity.

    1. Check that there is a continuity between terminals at each switch position as shown in the chart.

      Standard:
      Switch operation
      Tester connection
      Specified condition
      OFF
      -
      No continuity
      HEAD
      13 - 16 - 14
      Continuity



NG
REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (BETWEEN BODY ECU AND HEADLIGHT DIMMER SWITCH ASSEMBLY)
  1. Check the continuity terminal B6-1 (HEAD) of the multiplex network body ECU and the headlight dimmer switch assembly.

    Standard:
    There is continuity



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX NETWORK BODY ECU