Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
According to the DATA LIST displayed by the intelligent tester, you can read the value of the switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as a first step of troubleshooting is one of the methods to shorten labor time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. According to the display on tester, read the "DATA LIST".

    Item
    Measurement Item/Display (Range)
    Normal Condition
    Diagnostic Note
    D DOR CTY SW
    Driver's door courtesy SW signal/ON or OFF
    ON: Driver's door is open
    OFF: Driver's door is close
    -
    P DOR CYT SW
    Passenger's door courtesy SW signal/ON or OFF
    ON: Passenger's door is open
    OFF: Passenger's door is close
    -
    Rr DOR CTY SW
    Rear door courtesy SW signal/ON or OFF
    ON: Either right or left rear door is open
    OFF: Both the right and left doors are closed.
    -
    HIGH FLASHER SW
    High flasher SW signal/ ON or OFF
    ON: High flasher SW is on
    OFF: High flasher SW is off
    -
    AUTO LIGHT SW
    Auto light SW signal/ON or OFF
    ON: Light control SW is in Auto position
    OFF: Light control SW is in except Auto position
    -
    HEAD LIGHT SW
    Head light SW signal/ON or OFF
    ON: Light control SW is in HEAD position
    OFF: Light control SW is in except HEAD position
    -
    TAIL LIGHT SW
    Taillight SW signal/ON or OFF
    ON: Light control SW is in TAIL or HEAD position
    OFF: Light control SW is in OFF or AUTO position
    -
    ACC SW
    ACC SW signal/ON or OFF
    ON: IG key is in ACC, ON or START position
    OFF: IG key is in OFF position
    -
    IG SW
    IG SW signal/ON or OFF
    ON: IG key is in ON or START position
    OFF: IG key is in OFF or ACC position
    -


ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the intelligent tester allows the relay, VSV, actuator and so on to operate without parts removal. Performing the ACTIVE TEST as a first step of troubleshooting is one of the methods to shorten labor time.
It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. According to the display on tester, perform the "ACTIVE TEST".

    Item
    Test Details
    Diagnostic Note
    HAZARD
    Turns Hazard light flasher relay ON/OFF
    -
    DRL RLY
    (Test Details)
    Turns DRL relay ON/OFF
    (Vehicle Condition)
    IG SW is ON, Engine is stopped and Light control SW is in OFF position.
    -
    HEAD LIGHT
    Turns Head light relay ON/OFF
    -
    TAIL LIGHT
    Turns Taillight relay ON/OFF
    -
    ILLUMI OUTPUT
    (Test Details)
    Turns Interior light and Key illumination ON/OFF
    (Vehicle Condition)
    Interior light SW is in Door position
    -
    DOME RLY CUT
    Dome relay cut ON/OFF
    -