Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat Type LH Side)

FRONT SEAT ASSEMBLY (for Manual Seat Type LH Side) > REMOVAL

for Preparation Click here


CAUTION:
  1. Always wear gloves because the sharp edges of the seatback frame and seat adjuster may cause injury.
  2. Work must be started 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.
    (The SRS is equipped with a back-up power source. If work is started within 90 seconds after disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

HINT:
  1. Installation is in the reverse order of removal. However, only installation procedures requiring additional information are included.
  2. Use the same procedures for the RH side and LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).
  4. COMPONENTS: Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL


2. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH
  1. Using a screwdriver, pry out the seat track bracket cover outer front LH.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH

HINT:
Removal procedure of the seat track bracket cover inner front LH is the same as for the seat track bracket cover outer front LH.



4. REMOVE SEAT TRACK OUTER COVER LH

HINT:
Removal procedure of the seat track outer cover LH is the same as for the seat track bracket cover outer front LH.



5. REMOVE SEAT TRACK BRACKET COVER INNER LH

HINT:
Removal procedure of the seat track bracket cover inner LH is the same as for the seat track bracket cover outer front LH.



6. REMOVE FRONT SEAT ASSEMBLY LH
  1. Disconnect the connectors under the front seat assembly LH.

  1. Remove the 4 bolts and front seat assembly LH.

    NOTICE:
    Be careful not to damage the body.