STARTER (for Cold Area) > REMOVAL |
| 1. DISCONNECT BATTERY NEGATIVE TERMINAL (for 2WD) |
Disconnect the negative battery terminal.
| 2. REMOVE ENGINE REAR UNDER COVER ASSEMBLY (for 2WD) |
Remove the 4 bolts and engine rear under cover assembly.
| 3. REMOVE NO. 2 MANIFOLD STAY (for 2WD) |
Remove the 3 bolts and No. 2 manifold stay.
| 4. DISCONNECT WIRE HARNESS (for 2WD) |
Remove the bolt and disconnect the wire harness from the cylinder block.
| 5. REMOVE STARTER ASSEMBLY (for 2WD) |
Disconnect the terminal 50 connector from the starter assembly.
Remove the nut and disconnect the wire harness from the terminal 30.
Remove the 2 bolts and starter assembly.
| 6. DISCONNECT BATTERY NEGATIVE TERMINAL (for 4WD) |
Disconnect the negative battery terminal.
| 7. REMOVE ENGINE REAR UNDER COVER ASSEMBLY (for 4WD) |
Remove the 4 bolts and engine rear under cover assembly.
| 8. REMOVE NO. 2 FRONT EXHAUST PIPE ASSEMBLY (for 4WD) |
Disconnect the heated oxygen sensor (bank 2) connector.
Remove the 2 bolts, 2 nuts, No. 2 front exhaust pipe assembly and 2 gaskets.
| 9. REMOVE FRONT FENDER REAR SPLASH SHIELD LH (for 4WD) |
![]() |
Remove the 5 clips and front fender rear splash shield LH.
| 10. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY (for 4WD) |
![]() |
Loosen the bolt A and remove the bolt B, then separate the No. 2 steering intermediate shaft sub-assembly.
| 11. REMOVE STARTER ASSEMBLY (for 4WD) |
Disconnect the terminal 50 connector from the starter assembly.
Remove the nut and disconnect the wire harness from the terminal 30.
Remove the 2 bolts and starter assembly.