Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR


    A134404
  1. Install the camshaft position sensor with the bolt and stud bolt.

    Torque:
    7.5 N*m{ 80 kgf*cm , 66 in.*lbf }

  1. Reconnect the camshaft position sensor connector.



2. INSTALL TIMING BELT COVER SUB-ASSEMBLY NO. 3 LH


    A014424
  1. Install the timing belt cover sub-assembly with the 4 bolts.

    Torque:
    7.5 N*m{ 80 kgf*cm , 66 in.*lbf }

  1. Install the camshaft position sensor connector and grommet to the timing belt cover.



3. INSTALL OIL COOLER PIPE
  1. Install the oil cooler pipe with the bolt and nut.

    Torque:
    7.5 N*m{ 80 kgf*cm , 66 in.*lbf }

  1. Connect the 3 hoses.



4. INSTALL FAN AND GENERATOR V BELT


    A053117E01
  1. Set the V belt onto every parts except the No. 2 idler pulley, as shown in the illustration.

  1. Loosen the V belt by turning the belt tensioner counterclockwise.

  1. Set the V belt to the No. 2 idler pulley.



    A052038E01
  1. After installing a new belt, check that the mark is within the B range as shown in the illustration.



5. ADD ENGINE COOLANT
  1. Slowly fill the system with engine coolant.

    Capacity:
    12.3 liters (13.0 US qts, 10.8 lmp. qts)

    HINT:
    1. Use of improper coolants may damage the engine cooling system.
    2. Use only Toyota Super Long Life Coolant or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology consists of a combination of low phosphates and organic acids).
    3. New Toyota vehicles are filled with Toyota Super Long Life Coolant (color is pink, premixed ethylene glycol concentration is approximately 50 % and freezing temperature is -35°C (-31°F)). When replacing the coolant, Toyota Super Long Life Coolant is recommended.
    4. Observe the coolant level inside the radiator by pressing the inlet and outlet radiator hoses several times by hand. If the coolant level goes down, add the coolant.

    NOTICE:
    Do not substitute plain water for engine coolant.

  1. Install the radiator cap securely.

  1. Bleed the cooling system.

    1. Open the heater water valve while warming up the engine.

    2. Maintain the engine speed at 2,000 to 2,500 rpm and warm up the engine.

  1. Stop the engine and wait until the coolant cools down.

  1. Add coolant into the reservoir until the coolant level is FULL.



6. CHECK FOR ENGINE COOLANT LEAKS
  1. Fill the radiator with coolant and attach a radiator cap tester.

  1. Pump it to 118 kPa (1.2 kgf/cm2 17.1 psi), then check for leakage.



7. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY
  1. Install the throttle body cover sub-assembly with the 2 nuts.

    Torque:
    7.5 N*m{ 80 kgf*cm , 66 in.*lbf }