Home
›
ENGINE · 2UZ-FE
›
ENGINE CONTROL SYSTEM
›
ENGINE COOLANT TEMPERATURE SENSOR
ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals.
Resistance:
20°C (68°F):
2.32 to 2.59 kΩ
80°C (176°F):
0.310 to 0.326 kΩ
NOTICE:
If inspecting the water temperature sensor in water, prevent water from flowing into the terminals. After inspection, wipe the water off the sensor.