THROTTLE BODY > INSTALLATION |
| 1. INSPECT THROTTLE W/MOTOR BODY ASSEMBLY |
![]() |
Install a new gasket and the throttle body with the 3 bolts and nut.
![]() |
Connect the water by-pass hose, water by-pass hose No. 7 and throttle position sensor connector.
| 2. INSTALL AIR CLEANER HOSE ASSEMBLY |
| 3. ADD ENGINE COOLANT |
Slowly fill the system with engine coolant.
Install the radiator cap securely.
Bleed the cooling system.
Open the heater water valve while warming up the engine.
Maintain the engine speed at 2,000 to 2,500 rpm and warm up the engine.
Stop the engine and wait until the coolant cools down.
Add coolant into the reservoir until the coolant level is FULL.
| 4. CHECK FOR ENGINE COOLANT LEAKS |
Fill the radiator with coolant and attach a radiator cap tester.
Pump it to 118 kPa (1.2 kgf/cm2 17.1 psi), then check for leakage.
| 5. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY |
Install the throttle body cover sub-assembly with the 2 nuts.